is it possible to only run 2 channels on a 4 channel amp?

amp is a RF p450.4

was thinking of removing rear channels inputs and ouputs to see how it sounds.

Do i need to provide either input or output or a minimal load to do it safely?

thanks in advance
Glen

 

absolutely no problem...any 2 channels on that amp can run safely as low as 2 ohms unbridged. you may also want to try bridging to 2channels and doubling power into those two channels...just beware that in bridged mode the minimum impedance is 4ohms per channel.

 

great thanks,

my speakers are rated 4 ohms so that should work.

thanks again.

 

No problem