Power Acoustik ?
i am looking into buying a couple of there amps because they look preety decent for the price per power they give. anyone have any experience with this gear . ( im looking at the gothic series of amps) im also considering buyign some of there components.
any coments would be nice. thanks
any coments would be nice. thanks
Their component are good for the price but try to find something better, the crossover and tweeter are good but the mid
. And for the amp take the LT series they are just a little more powerful, they are a bit overrated but not very much. Buy them from the state they are half the price(even with shipping, duty and tx ) then the Canadian msrp. http://www.etronics.com/brandscatego...=PowerAcoustik
. And for the amp take the LT series they are just a little more powerful, they are a bit overrated but not very much. Buy them from the state they are half the price(even with shipping, duty and tx ) then the Canadian msrp. http://www.etronics.com/brandscatego...=PowerAcoustik
I have a 6 yr old Fire and Ice 1600.. identical foot print to the gothic series..
I have repaired the amp 3 times.. the solder joints where the rca's go it always come loose, so every couple years i will loose the left channel (Cold Solder).. 8 screws, the board is out, re-soldered and im good to go..
For the power.. I have a Autosound and security mag that did a test report.. -370w per channel 4 ohm load.. I run it 3Ohm a side for approx 450 to 500watts.. my subs pound like crazy.
It will run Mono 3Ohm as i had it running one sub, but protection flips on running at 1.5ohm.
I almost forgot.. my flourescent tube blew a few years back.. I remplaced it with a red cold cathode, same as what a computer uses,, looks nicer and not as ambient of lighting..
For the Price they rock..
[ July 22, 2004, 12:46 AM: Message edited by: Rockney ]
I have repaired the amp 3 times.. the solder joints where the rca's go it always come loose, so every couple years i will loose the left channel (Cold Solder).. 8 screws, the board is out, re-soldered and im good to go..
For the power.. I have a Autosound and security mag that did a test report.. -370w per channel 4 ohm load.. I run it 3Ohm a side for approx 450 to 500watts.. my subs pound like crazy.
It will run Mono 3Ohm as i had it running one sub, but protection flips on running at 1.5ohm.
I almost forgot.. my flourescent tube blew a few years back.. I remplaced it with a red cold cathode, same as what a computer uses,, looks nicer and not as ambient of lighting..
For the Price they rock..
[ July 22, 2004, 12:46 AM: Message edited by: Rockney ]
Thread
Thread Starter
Forum
Replies
Last Post



