requesting info on Kenwood's BMS compatibility...
#1
*edit- question about bass boost?
hey,
i had some compatibility questions between my amp and deck that have been answered. below i posted a question about bass boost on amps.. i'm sure someone will share their expertise/views with me hehe.
thanks so much!
i had some compatibility questions between my amp and deck that have been answered. below i posted a question about bass boost on amps.. i'm sure someone will share their expertise/views with me hehe.
thanks so much!
Last edited by crazykev81; 06-02-2006 at 04:49 PM.
#2
ok i think its sorted out!
apparently all i need is a length of 18ga copper wire, to connect the amp into the deck's "external amp control" on the deck's harness.. thanks!
*** so anyway my sub is in a 1.75 cu/ft box, tuned to 38Hz.. what would +6, +12, or +18 dB of bass boost do? the lowest the setting goes is 40Hz. where would be the best to set it for my application? or is it best to wait until the deck goes back in and do it by ear? i guess my main concern is distortion, what do you guys think of bass boost, is it good or bad? and how do you use it properly? (assuming gains are set at 5.0v with 5.0v preouts on deck)
thanks in advance!
apparently all i need is a length of 18ga copper wire, to connect the amp into the deck's "external amp control" on the deck's harness.. thanks!
*** so anyway my sub is in a 1.75 cu/ft box, tuned to 38Hz.. what would +6, +12, or +18 dB of bass boost do? the lowest the setting goes is 40Hz. where would be the best to set it for my application? or is it best to wait until the deck goes back in and do it by ear? i guess my main concern is distortion, what do you guys think of bass boost, is it good or bad? and how do you use it properly? (assuming gains are set at 5.0v with 5.0v preouts on deck)
thanks in advance!
Last edited by crazykev81; 06-02-2006 at 04:52 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Kwalsh24
Install related
3
06-17-2004 02:30 PM