Rockford Fosgate POWER T30001BD
 

Will this amp run @ 0.5 ohm daily with:

2 runs of positive in 1/0
4 runs of ground in 1/0 (to the frame)
Optima Yellow Top as starter batt
Batcap 2000 in the trunk
Stock alt (100A)


Has anybody ever run this amp @ a 0.5 ohm load?

You should check out steve meade designs forum, alot of rockford discussions on there you may find what youre looking for there.

Mike, I've heard of them running at impedances below what they're rated for, but the most I've ever done to a rockford was run a P3002 at 1 ohm. My gut tells me it will work at .5 if its rated 1 ohm stable, but I can't guarantee it.

don't know about doing that daily but there's only one way to find out Mike.

good point on checking out the SMD forum. i shall do that

i've heard of people running them at .7 ohms and not having a problem, although they had much better electrical than i have stated.

only thing i figure is that after imp rise and all that other garbage, it should be alright.

Willcan had a 1000 which he burped at 0.5 but don't know what if he ran it at that for daily. send him pm :smokin:

thanks bro.

no worries dawg. Yo shoulda came today mang.:smokin:

I'm working silly hours at the LCBO this holiday season so I couldnt make it. I also dont have any equipment in my car...

Although i do have a 15" subwoofer sitting beside me....

I burp at .35 om my t3001, but i have to roll up the volume. I only have one run of + - of 0 gauge, stock 110 alt and two batts. Gonna try running it at .7 for daily, hopfully it will take it:dunno:.