setup question
Thread Starter
0 Watt CAFz'r
Joined: May 2006
Posts: 4
setup question
I have the following setup:
Kenwood KDC-mp832u deck
Infinity 7451a (4 -channel) amp
Alpine Type R 6.5 inch comps (70 Watts rms)
Polk Momo MM12 sub (500 Watts rms)
I'll have 111 watts rms from the amp for each of the components, which I think is fine (its good to have headroom, right?).
I'm planning to bridge 2 channels (278 watts rms) for the sub. Since the sub can handle 500 watts rms will I have problems because its not enough power?
Kenwood KDC-mp832u deck
Infinity 7451a (4 -channel) amp
Alpine Type R 6.5 inch comps (70 Watts rms)
Polk Momo MM12 sub (500 Watts rms)
I'll have 111 watts rms from the amp for each of the components, which I think is fine (its good to have headroom, right?).
I'm planning to bridge 2 channels (278 watts rms) for the sub. Since the sub can handle 500 watts rms will I have problems because its not enough power?
Thread
Thread Starter
Forum
Replies
Last Post
Hardcore Rock Superstar
General Discussion
1
May 2, 2004 02:21 PM
