tpcustomauto

trying to make a decision between 6 rex10 d4 or one re sx18 d2 they will be in a ported box tune 35hz running off a ppi pcx2200 just want to hear some opinions for each on both spl and sq

Livin Louder

iTrader: (1)

Tell us more about what you want your syetm to do! music wise, What vehicle? what box sizing?
6-10's will probably need different box then 1-18". I like 18's if your listening to bassss music! Sounds like a ncie setup though!

Get us some pics!

fresh1

iTrader: (2)

10''s will look cooler, but a lot of people who have never seen a 18'' sub tend to be shocked to know such things exist and they know someone with one

JDN1014

6 10s will sound better even 4 10s will be better especially if its in a trunk car

Lord Huggington

iTrader: (1)

Almost double the cone area with 6 10's. Check the efficiency, it might not matter.

tpcustomauto

it's going in a vw golf I've go room for a 7.5 cuf box including port volume, to 6 10 will be running around 2.5 ohm to two channels and the 18 I would be running in series bridging the amp at 4 ohms, everything will be running through audio control 2xs and eqq, fronts are 6 3.5 jbl's rears are 4 6.5 alpine type s running off ads pq10 and pq15

Lord Huggington

iTrader: (1)

Six DVC 4 ohm subs wires into either 1.3 or 0.33 ohms. Your amp does 800W x 1CH @ 4 ohms or 400W x 2CH in 2 ohms. You can't use 6 DVC 4's with that amp because it isn't stable below 2 ohms. A DVC 2 ohm sub wires into 1 or 4 ohms so it would be a good match for 800W @ 4 ohms. If you want to use six 10's with daily-driver power, consider six SSA DCON 10's (SVC 4 ohm) @ 0.67 ohms / 1800W RMS.

http://pinq.wordpress.com/2007/05/11...l-voice-coils/

dbs

6 10s
tunnel ?

goalie 35

due a tekton 21.. that will show em..

Lord Huggington

iTrader: (1)

"The Tekton drivers are made in Italy and no longer available in the US. The cost was high at about $1000 a driver!"