Car Audio Forumz - The #1 Car Audio Forum

Car Audio Forumz - The #1 Car Audio Forum (https://www.caraudioforumz.com/)
-   General Discussion (https://www.caraudioforumz.com/general-discussion-10/)
-   -   System not quite complete (https://www.caraudioforumz.com/general-discussion-10/system-not-quite-complete-400/)

Mullen 03-15-2004 08:40 AM

Ok this weekend was busy on Saturday I installed my infinity's front and rear (sorry no pic's [img]graemlins/dawg.gif[/img] haha but I was pressed for time I needed to get them in and working for sunday's deck install plus it was dam cold in my garage. So to my question as you see in my sig I have a RF301x this amp is proving to be a little weak in powering my system I am looking for sugestions on amp combo's. Keeping in mind that I got my peepee slap by wifie for blowing the budget for the new speaks and deck plus other goodies (she won't find untill she gets the credtitcard bill :D ) So nothing to extreme. Looking for a stealthy install maybe a 5 channel???

[img]graemlins/beer.gif[/img]

[ March 15, 2004, 09:49 AM: Message edited by: Mullen ]

Dereck Waller 03-15-2004 10:52 AM

How do you mean "weak". I have used as little as 35 watts RMS to each of four speakers and they got loud enough to hurt your ears when cranked up, how are your gains set? Any other processing on the deck used? What are the crossovers on the amp like. Remember you have to double your power to get +3 db, and you need 10X the power for it to seem twice as loud to your ears.

Mullen 03-15-2004 12:01 PM

Yah its loud I guess I need to spend some time in tweeking But damn that Alpine I-personalize is just way over my head. If somebody could give a heads-up on it that would be a start.

My gains are set full with 1/4 turn back
Crossovers set at all pass for comps
low pass for sub
rears are fed by deck

The SQ has improved lots

[img]graemlins/beer.gif[/img]

[ March 15, 2004, 01:04 PM: Message edited by: Mullen ]

Hardwrkr 03-15-2004 12:03 PM

That amp should be just fine on the components.
Now if you have your sub on there too you may want to look for a matching bd500 for it.

Mullen 03-15-2004 12:07 PM


Originally posted by Hardwrkr:
That amp should be just fine on the components.
Now if you have your sub on there too you may want to look for a matching bd500 for it.

Yah channel 3 and 4 are bridged to the sub 1 and 2 are comps. So you suggest I bridge the 4channels to the comps and get a mono amp for the sub??

[img]graemlins/beer.gif[/img]

99AltimaGXE 03-17-2004 07:24 PM

At one point I was in the same predicament is you.....

since then I've sold the 4 chan.... been through a couple sub only systems, and now I have a 1000bd for the subs, and a 550S for my comps.... unfortunately, my car is and will be sitting on the side of the house and in the garage until sept. when I get my liscence back (long story) ...

Mullen 03-18-2004 06:14 AM

Man I wouldnt want to pay your insurance bill.
Ya I guess my system will always be evolving first I need a top notch box for my sub. and the probably a mono amp for it

later


All times are GMT -5. The time now is 09:14 PM.


© 2024 MH Sub I, LLC dba Internet Brands