Under Hung Motor VS XBL^2
Thread Starter
0 Watt CAFz'r
Joined: Oct 2003
Posts: 1
here is a cut and paste from
http://acoustic-visions.com/forums/i...?showtopic=984
"Dan Wiggins"
I've uploaded a couple of fun WAV files you can listen to:
http://www.adireaudio.com/Files/Dan/XBL-IMD-Test.wav
and
http://www.adireaudio.com/Files/Dan/UH-IMD-Test.wav
These are the results of equal BL/Fs/Vas drivers, each optimized as best as possible. We ran simultaneously 70 Hz and 735 Hz into each driver, and pushed each driver to 70% of linear excursion. Then recorded the results. The two 4 second wave files above.
Take a listen, which one do you think sounds better? Remember, you should only hear 70 Hz and 735 Hz. Everything else you hear is distortion - Intermodulation distortion.
We did this set of files (and will have more coming, too) to show the audible benefits of XBL^2 motors. It's one thing to see it in writing; it's another to actually hear the differences.
Dan Wiggins
Adire Audio
http://acoustic-visions.com/forums/i...?showtopic=984
"Dan Wiggins"
I've uploaded a couple of fun WAV files you can listen to:
http://www.adireaudio.com/Files/Dan/XBL-IMD-Test.wav
and
http://www.adireaudio.com/Files/Dan/UH-IMD-Test.wav
These are the results of equal BL/Fs/Vas drivers, each optimized as best as possible. We ran simultaneously 70 Hz and 735 Hz into each driver, and pushed each driver to 70% of linear excursion. Then recorded the results. The two 4 second wave files above.
Take a listen, which one do you think sounds better? Remember, you should only hear 70 Hz and 735 Hz. Everything else you hear is distortion - Intermodulation distortion.
We did this set of files (and will have more coming, too) to show the audible benefits of XBL^2 motors. It's one thing to see it in writing; it's another to actually hear the differences.
Dan Wiggins
Adire Audio
Thread
Thread Starter
Forum
Replies
Last Post
