voice coil questions
04-12-2009, 12:30 AM
#1
voice coil questions
okay so both my coils on my dvc4 typer are both read 4.1on the dmm, i checked today when my sub was out of the box and i put the sub back in the box after i failed on a box build today. and just went driving and the subs starting to smell again it did this a bit when i got it all hooked up to my new amp last sat, if the dmm says its 4ohms on each coild could i be frying the vc? or what could be causing the smell i had the smell wayy back in jan i hada thread about it and people said i was either blowing it or the break in and im sure it was the break in cuz after a while the smell went away.
04-12-2009, 07:38 AM
#2
okay so both my coils on my dvc4 typer are both read 4.1on the dmm, i checked today when my sub was out of the box and i put the sub back in the box after i failed on a box build today. and just went driving and the subs starting to smell again it did this a bit when i got it all hooked up to my new amp last sat, if the dmm says its 4ohms on each coild could i be frying the vc? or what could be causing the smell i had the smell wayy back in jan i hada thread about it and people said i was either blowing it or the break in and im sure it was the break in cuz after a while the smell went away.
04-12-2009, 09:26 AM
#6
04-12-2009, 09:30 AM
#8
Assuming that you have it set correctly and its not clipping, beats me... 
I had a similar problem when my subs were ported, but it was due to my subs unloading below the port frequency. Are you using any specific software to model these boxes?
I had a similar problem when my subs were ported, but it was due to my subs unloading below the port frequency. Are you using any specific software to model these boxes?
