I have a Crunch Power Zone PZA1400.2 2 Channel Amplifier 350 x 2 @ 4 OHMS, 700 x 2 @ 2 OHMS - 1400 Watts x 1 @ 4 OHMS with Illuminated Badge in my trunk already.

I want to to buy two skar vvx-10" subwoofers. I was going to buy both woofers in 2ohms. I want to know how to wire them at 700 watts each? Or do I need the 4ohms?

Btw: I've been looking at crutchfeild and sonic electronics wiring diagrams but, I don't understand if there 700 watts each?
Thanks!

 

Get dual 4ohm subs so each sub has a dual 4 ohm voice coil ...this way you can wire them together in series/parallel for 4ohm bridged on the amp or you can wire them at 2ohm each per channel.... Also if you decide to get a big mono amp that does max power at 1 ohm you can parallel the subs down to 1 ohm

 

That amp is 1400 watts peak so expect around 700 watts rms out of it. So each subwoofer will get 350 watts rms. You wil want the dial 4 ohm subs as stated above

 

And more than likely you wont even get that^ out of the amp... Expect to see less than 300rms per channel..., i would suggest getting one vvx 12 or 15 dual 2ohm to teally get the most out of the sub