zapco studio 500

Reply Subscribe

Thread Tools

Search this Thread

May 5, 2006 | 08:44 AM

Zapcofan

Thread Starter

0 Watt CAFz'r

Joined: May 2006

Posts: 8

zapco studio 500

I have a studio 500 running my boston pro 6.43 pseakers.I have it running 250rms at 4ohm.Would it benfit me to byamp the crossover and get a 2ohm load?That will double the power but I can't use 1/4 of the power I have now.Another question I have is on subs.I have a 10in. fusion powerplant,I'm thinking about going to a dd audio 2512,Would this be a big step up?I'm also looking at Image dynamics.

May 5, 2006 | 09:03 AM

defro13

Guest

Posts: n/a

biamping your spekaers through passives doesnt give you a 2 ohm load, your confused, the benefit you would get is the ability to control speaker level with amp gain and this can be a very nice thing to have, as for the woofer amp

May 5, 2006 | 09:12 AM

theboy

1000 Watt CAFz'r

Joined: Aug 2004

Posts: 1,267

What Defro meant to say was ...a studio 500 is a garbage amp,run something else and sell it to him!

May 5, 2006 | 09:41 AM

Zapcofan

Thread Starter

0 Watt CAFz'r

Joined: May 2006

Posts: 8

I can byamp the 6.5in woofers through the 3way crossover.I just assumed that if I byamped tha crossover to feed the midbass,it would be a 2ohm load?The amp is about the best I have listened to.I'm blown away by the speakers and the amp.

May 5, 2006 | 10:50 AM

defro13

Guest

Posts: n/a

common misconception, the impedance will only lower when you run multiple speakers through the same bandwidth, eg 2 6.5" midbass' in parallel through a bandwidth of 100-500, through that bandwidth the impedance will be 2 ohms, assuming 4 ohm speakers