Attn: AB200.1, Ext 3000d , E-3000d and Collossus Owners.
#14
You guys are scaring me as I also have this same board in my AB200.1..
I know i have blown the outputs and so did the previous owner.. both times S&S repaired it and now is working great again..
Am I now going to run into this issue with mine on the parts for it??
I know i have blown the outputs and so did the previous owner.. both times S&S repaired it and now is working great again..
Am I now going to run into this issue with mine on the parts for it??
#15
the main ussues are usually brought on by the board not being supported in the middle(broken fet legs).
i'm modifying all of mine..11 and 12mm phenolic or plastic spacers and drilled/tapped heatsink.(note the three holes in the middle of the board)
i'm modifying all of mine..11 and 12mm phenolic or plastic spacers and drilled/tapped heatsink.(note the three holes in the middle of the board)
#16
Originally Posted by MTA
hey jordy i sometimes buy from future electronics online...
IF i find the boards or IC's that are being mentioned here I willl be ordering some 360's also
IF i find the boards or IC's that are being mentioned here I willl be ordering some 360's also
May have to do the mods that Rob mentioned to support the rest of the board...
#17
i'm socketing the output controller board too, that way i can change it without pulling the main board out of the chassis.
i'm ordering extra boards if they are available, just have spairs and mabe help a few people get their amps together, it's all a matter of time.
i'm ordering extra boards if they are available, just have spairs and mabe help a few people get their amps together, it's all a matter of time.
Thread
Thread Starter
Forum
Replies
Last Post
Loud Brown Kicker Colt
Car Audio Wanted (WTB)
2
06-28-2007 08:46 PM
Cavalier Chunk
General Discussion
12
12-29-2004 10:45 AM