Re Mt 12" low output
#11
Not on my amp its not
it is part of the intelli Q
Incorporated in the high-pass crossover, Intelli q maximizes performance of a sub-woofer,
the high-pass subsonic filter removes unwanted bass output from the woofer.
it is part of the intelli Q
Incorporated in the high-pass crossover, Intelli q maximizes performance of a sub-woofer,
the high-pass subsonic filter removes unwanted bass output from the woofer.
Last edited by 2loud4u; 09-20-2006 at 07:48 PM.
#12
A High pass filter and subsonic filter are completely different on anything I have seen, if you have your high pass filter on on your amp you will get almost no bass, and the bass you do get will not be low
Just try taking it off, its not going to hurt anything to try
Just try taking it off, its not going to hurt anything to try
#17
they are two completelly diff things.
set your shiit up like this
LPF all the way up on amp and deck. NO SLOP, PUT IT TO FLAT
HPF all the way down on amp and deck. NO SLOP, PUT IT TO FLAT
subsonic all the way down
sub xover on deck - all the way up. sub boost all the way down. loud ON!!
btw at 0.8 ohm that amp does about 1700 rms.
set your shiit up like this
LPF all the way up on amp and deck. NO SLOP, PUT IT TO FLAT
HPF all the way down on amp and deck. NO SLOP, PUT IT TO FLAT
subsonic all the way down
sub xover on deck - all the way up. sub boost all the way down. loud ON!!
btw at 0.8 ohm that amp does about 1700 rms.
Last edited by Prolifik; 09-20-2006 at 08:50 PM.
#19
oooooooooook and how do u know that it give that much power ?? did u clap and check your draw ?? anyways i think u just need to build a new box because the one u are using is probably the wrong size . Tell u what why dont u turn your box if u can and see how much u hit !!
hope it helps
hope it helps
#20
Yes I had it bench tested about 2 months ago.
Tried turning the box around but it did worse.
But I did not seal it off around the box.
I am thinking the same thing that the box needs to be replaced.
I do Hear alittle port noise so I will need more port area.
Just not sure on box size.
I am thinking
2.5 cuft after sub and port displacement
65-70 square inches of port area
tuned to about 36-38hz
That is the only thing I can think of that it is the box.
Tried turning the box around but it did worse.
But I did not seal it off around the box.
I am thinking the same thing that the box needs to be replaced.
I do Hear alittle port noise so I will need more port area.
Just not sure on box size.
I am thinking
2.5 cuft after sub and port displacement
65-70 square inches of port area
tuned to about 36-38hz
That is the only thing I can think of that it is the box.