93 grand Marquis
08-30-2006, 06:17 AM
#1
Guest
Posts: n/a
93 grand Marquis
ok, so i was having trouble getting the factory deck out, but i ended up breaking the whole deck, just around the edges so i could get soemthign in there to push those clips on the side in....
my questions are, how do i put a new deck in?....
do u bust the rivets holding those clips on?...
also those clips dont look like they can go anywhere on my deck...am i missing soemthing?...
the guy at the audio shop said it was straight forward and there was no aftermarket mounting hardware required.....any help would be greatly apreciated...thanks in advance..
Mat
my questions are, how do i put a new deck in?....
do u bust the rivets holding those clips on?...
also those clips dont look like they can go anywhere on my deck...am i missing soemthing?...
the guy at the audio shop said it was straight forward and there was no aftermarket mounting hardware required.....any help would be greatly apreciated...thanks in advance..
Mat
09-01-2006, 08:49 AM
#3
well I am almost certain, when you get the metra kit for this vehicle that it is supposed to just clip into place, and then that holds it in place, my buddies ranger is the same way , and I think its a horrible system , but it holds his indash screen even while its coming out it never falls out..
09-03-2006, 02:04 PM
#7
That car is easy like most fords
1,get some uninstall keys
2,insert remove radio
3,solder all your conections
4,take mounting cage,snap it into place with tabs
5,take new HU with locking clips on side
6,slide it in
From the factory radio yiu broke did it say automatice on Cassete portion
1,get some uninstall keys
2,insert remove radio
3,solder all your conections
4,take mounting cage,snap it into place with tabs
5,take new HU with locking clips on side
6,slide it in
From the factory radio yiu broke did it say automatice on Cassete portion
Thread
Thread Starter
Forum
Replies
Last Post
rajadesi
General Discussion
7
06-14-2004 06:37 PM
