Amp Power...
#1
Amp Power...
***Noob Here***
Ok so I have a 10" DVC Subwoofer at 4 Ohms...Says 250 RMS 500w Peak...Now if I run it parallel I will get 2 Ohms Correct? My Amp Says it will push 500w RMS at 2 Ohms...is this waaay too much power? Should I Run it in Series to get the 8 Ohm load? I believe this might slightly underpower sub but will keep it in a safe zone correct? Or can I still run the 2 Ohm Load with just some tuning of the power on the amp.
Ok so I have a 10" DVC Subwoofer at 4 Ohms...Says 250 RMS 500w Peak...Now if I run it parallel I will get 2 Ohms Correct? My Amp Says it will push 500w RMS at 2 Ohms...is this waaay too much power? Should I Run it in Series to get the 8 Ohm load? I believe this might slightly underpower sub but will keep it in a safe zone correct? Or can I still run the 2 Ohm Load with just some tuning of the power on the amp.
Thread
Thread Starter
Forum
Replies
Last Post
sirsleepsalot
General Discussion
7
05-07-2006 10:15 AM