Help! Installing 2 12" DVC subs and Amp.
#1
Hey all, can you please guide me how to install this stuff? wiring and all...
have 2 compvr 12's their 2ohm dvcs
amp is a kicker kx600
how do i wire the stuff so i can run the full 600rms @ 2ohm off the amp?
firstly.. how do i wire the subs, kuz there dual ohm, and also the terminals on the box.. diagrams would be swwweeeet but i think i could understand plain englishh lol
have 2 compvr 12's their 2ohm dvcs
amp is a kicker kx600
how do i wire the stuff so i can run the full 600rms @ 2ohm off the amp?
firstly.. how do i wire the subs, kuz there dual ohm, and also the terminals on the box.. diagrams would be swwweeeet but i think i could understand plain englishh lol
#4
Guest
Posts: n/a
On EACH speaker:
Go from one (+) to one (-). That will leave you with one empty (+) and one empty (-).
Now, connect each (+) together and go to the box terminal (+). Do the same with the (-).
... and yes, this is the extent of my drawing skills.
[ May 11, 2004, 11:39 AM: Message edited by: Ettore Casagrande Jr. ]
Go from one (+) to one (-). That will leave you with one empty (+) and one empty (-).
Now, connect each (+) together and go to the box terminal (+). Do the same with the (-).
... and yes, this is the extent of my drawing skills.
[ May 11, 2004, 11:39 AM: Message edited by: Ettore Casagrande Jr. ]
#8
yea, iam looking at that, looks good. but main concern is do i connect it to one terminal... so join the 2 +'s from each sub and the 2 - then connect it to a connector on the box. or do i use the 2 connector boxes on the box. Then how do i wire it to the amp if i use only one terminal box? stick one + in the left/right? - leftright? im confused.
Thread
Thread Starter
Forum
Replies
Last Post
Jmon
Car Audio Technical Discussions
2
09-26-2012 01:16 AM
OPPressed
General Discussion
6
09-24-2007 02:49 PM
OrionMan
Car Audio Wanted (WTB)
0
04-16-2006 08:19 PM