Monoblock Amp with 2 speaker terminals??
Thread Starter
0 Watt CAFz'r
Joined: Apr 2008
Posts: 21
Monoblock Amp with 2 speaker terminals??
how is this supposed to be connected to the speaker? + - on either side? or + - bridged across?
i have the speaker wired in parallel (its 2 ohm DVC) for a 1 ohm load.
the amp is 1 ohm stable
i have the speaker wired in parallel (its 2 ohm DVC) for a 1 ohm load.
the amp is 1 ohm stable
2000 Watt CAFz'r
Joined: Jan 2001
Posts: 2,026
^^^ Ditto.
It is basically for ease of set-up. With your situation you wire one VC to one set of +,- and the second VC to the other set of +,-. This way you don't have to try and squeeze two wires into one terminal, or use a VC terminal as a jumper to another VC or sub.
Nothing fancy about it. Now power out-put differences either (you could hook-up three 4 ohm VCs to one terminal and one 4 ohm vc to the other and still have a 1 ohm final load. Just an internal splitter to make multiple sub hook-ups easy.
It is basically for ease of set-up. With your situation you wire one VC to one set of +,- and the second VC to the other set of +,-. This way you don't have to try and squeeze two wires into one terminal, or use a VC terminal as a jumper to another VC or sub.
Nothing fancy about it. Now power out-put differences either (you could hook-up three 4 ohm VCs to one terminal and one 4 ohm vc to the other and still have a 1 ohm final load. Just an internal splitter to make multiple sub hook-ups easy.
Thread
Thread Starter
Forum
Replies
Last Post
nb23
Car Audio Wanted (WTB)
6
Oct 12, 2010 04:50 PM
