Eric1212

COuld anyone make a wiring diagram showing how to wire 2 front speakers, 2 backs, 2 subwoofers, mono amp, 4 channel amp, a capacitor and a deck with 3 rca outputs.

Ask for any info thanks.

zzzzzzz

iTrader: (5)

does your deck have rca outs ?


if tes rca's to amps ,wire amp to speakers ,wire amp to sub ,run power to amps (use a fuse)run a wire form your deck to amps so they will go on

sorrey my son is making this hard to tpy

Eric1212

Ya it has 3 rca outputs front sub and back but how do I wire in the capacitor and should i run the speakers parraleell or what.

zinger002

iTrader: (1)

are the subs svc or dual coil? and rated at how many ohm's
what is the amp rated for aswell.

Eric1212

I beleive they are dual voice coil rated at 300wrms 2 ohms. they are dual mtx sledgehammer enclosure from futures shop.

Bossmaan

took this from crutchfield...this should help you out a bit



that pic uses a ground block..i have a cap installed as well.. i got my power going from battery to cap, and cap to MONO amp..and i grounded my 3 things..(cap, 4 chan, mono) to the same spot and it's been workin great, no hissing or anything from speakers..i dont like using ground blocks..if its not done right you can get gay *** noise through your speakers..if you can get a good ground point, it should be fine.. oh and if ur gonna buy a wiring kit that's fine, but if you decide to buy just cables and diy..don't get seperate fuses and distro blocks..get a fused distro block..you can get a knukoncepts for $20 from ebay..

Tom.F.1

iTrader: (1)

Good picture.

There are a whole bunch of people who should look at that instead of asking newbie questions.

The manual from any high end deck also has a basic install diagram.

Eric1212

Those diagrams help alot but you have 1 power wire to a distribution block wouldnt it be better to run 2 seperate wires instead of trying to powrr 2 amps through 1. Also I was told instead of hooking up a capacitor to change my BIG # wires with 0/1 guage wire and it will give alot more power then a capacitor will. Does anyone know a good online place to order power wire.

Tom.F.1

iTrader: (1)

Eric, you might notice in the picture that it is a bigger wire before the fuse block, usually # 4 to 1/0, and smaller wire to each amp. I use 1/0 with a 100 amp fuse to a 4 way fuse bock, then # 6 to each amp. You can't fit 0 into most amps.
I also have my caps on the battery side of the fuse block so that all amps can benefit from the cap, not just the sub amps.
I have all the amp and cap grounds connected at the same point, but others say they should be grounded separately. Whatever works.