Dumbest thing you've ever done in an install?
#1
Dumbest thing you've ever done in an install?
I thought this would be an amusing topic..
The thing that you did and immediately after just facepalm and walk away for a few minutes in embarrassment even if nobody is with you
Share yo stories!
I ain't going first though. xD
The thing that you did and immediately after just facepalm and walk away for a few minutes in embarrassment even if nobody is with you
Share yo stories!
I ain't going first though. xD
#2
Ummmm ordered a new amp over a blown fuse was stupid, embarrasing and expensive, I have a nicer amp now but still, it was a fuse in the distrobution block, I forgotten that it was smaller then what it was suposed to becuase it was all I had at the time,
#3
brand new ZX1500.1 just out of wrapper ....... + and - just wasnt labeled well enuff...... was to excited, had box and subs in the car for a month n a half while i waited for the amp( $$ ).....Needless to say it immediatly got bounced off the driveway. My wife still to this day reminds me of this episode
Now i dont think about how good it will sound.
i look over things 50x and enjoy how they do sound.
Now i dont think about how good it will sound.
i look over things 50x and enjoy how they do sound.
#5
Came home exhausted from work to find my new comp set at the front door. Took them inside and while looking over the nice new beefy mid it slipped out of my hand and smashed on the kitchen floor. It fell sideways so it got turned from a round speaker to a D-shape. Facepalm moment.
#8
While installing a component set in my door I dropped one of the mids on the pavement. It was dead.
This is recent, I was plugging an amp in front of my new buddy kevinmurray and (here is my excuse) in a rush wired the amp in reverse and burned a fuse and of course looked pretty stupid hehehe.
This is recent, I was plugging an amp in front of my new buddy kevinmurray and (here is my excuse) in a rush wired the amp in reverse and burned a fuse and of course looked pretty stupid hehehe.
#10
Had my 8 cube box and 2 loose 12's on my workbench, nudged box and knocked one of them 4 feet to the concrete. Gasping I picked it off the ground and the cone would'nt move in or out. A few days go by before I investigate further. I took a rubber mallet and knocked my mis-aligned pole piece back into position. Cone moves in and out, no rub, then I emptied the contents of a selfmixing epoxy onto my shattered motor. Needless to say, that sub is still pounding.