MR2NR

iTrader: (66)

You can use all 3 if you diode isolate two sensors so that they do not interfere with each other. Personally though, a motion sensor is a complete waste of time and almost a guaranteed way to **** you off through false alarms. A glass break sensor though.... definitely is the way to go, porcelain crystallizes a window and does not set off a impact sensor but it sure will set off a good glass break sensor.

Crashman2k9

iTrader: (2)

reallly? where can i get 1 of those diodes?

my alarm came stock with shock and ultra sonic but i can swap it for microwave


i hae a chose to disable with sensor i want

can u point me to an ebay link to buy these diodes?
Thanks!

Crashman2k9

iTrader: (2)

i have wiring for door and hood pins

i have 2 spot for any sensor,

let say i hook up the glass/motion/shock
ill puck the shock on it on circuit (sence that stock)

and use a diode to put the glass/motion

what diode do i use i usee it goes on the blue(signal) so it separate each other

Crashman2k9

iTrader: (2)

1N4000 are theses the diodes i need to run multiple sensors?

sam.hollis

I would do glass and shock and you shouold be fine. The prox seems to false alot

DeadlySones

iTrader: (4)

Thats due to improper installation position and/or set too high.