Compustar remote start problem
#1
Compustar remote start problem
Hey there, I have a 2002 honda civic manual sedan and I have purchased a compustar cm-7200 with idatalink blade-tb which I programmed and wired the unit. All main wires are connected correctly as far as I can tell. I tested handbrake, brake pedal, tach and learning completed, hood pin tested and door pins tested.
My problem is as follows. I set the reservation mode, the blade module flashes green twice. I then remove the key and the car keeps running. I open the door and close it the car stops but nothing more. The remote starter is supposed to shut down, lock and arm but nothing. I tried locking/arming but when I try to remote start I get the parking light flash error "reservation mode not set".
I must have forgotten a wire but I really don't know.
Any help whatsoever would be greatly appreciated.
My problem is as follows. I set the reservation mode, the blade module flashes green twice. I then remove the key and the car keeps running. I open the door and close it the car stops but nothing more. The remote starter is supposed to shut down, lock and arm but nothing. I tried locking/arming but when I try to remote start I get the parking light flash error "reservation mode not set".
I must have forgotten a wire but I really don't know.
Any help whatsoever would be greatly appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
prabhakarglv
Car Alarm and Mobile Security
9
04-10-2014 12:45 AM
1989TaurusSHO
Car Alarm and Mobile Security
6
08-09-2008 12:54 PM