I have a new SSL Evolution4000D amp and i am currently using 4GA wire, I had a kenwood 1800 watt class D Mono block amp with an axxess Line output converter. on the kenwood I have terminals for Battery, Ground, and P.Conn. on the SSL I have terminals for Battery, Ground, and Remote. on my Axxess LOC (line output converter) i have 4 wires showing (2 Black, 1 Yellow, and 1 Blue) on my old amp the blue was connected to the P.conn and yellow was to the battery. On my new amp it says that P.Conn is where you incert the ground wire. I don't remember where the 2 Black ones went because my amp doesn't have a designated P.Conn terminal. i need help figuring out where each wire goes. thanks

 

[QUOTE=Luciano;670308]I have a new SSL Evolution4000D amp and i am currently using 4GA wire, I had a kenwood 1800 watt class D Mono block amp with an axxess Line output converter. on the kenwood I have terminals for Battery, Ground, and P.Conn. on the SSL I have terminals for Battery, Ground, and Remote. on my Axxess LOC (line output converter) i have 4 wires showing (2 Black, 1 Yellow, and 1 Blue) on my old amp the blue was connected to the P.conn and yellow was to the battery. On my new amp it says that P.Conn is where you incert the ground wire. I don't remember where the 2 Black ones went because my amp doesn't have a designated P.Conn terminal. i need help figuring out where each wire goes. thanks[/QUOT




well the common standard for automotive color code wiring is black is common ground, red is power, blue is remote turn on. i have found that. p conn is blue. test it with an ohm meter or a power probe 3 first to determine load status positive or negative. also refer to the owners manual