Really could use some help!
#1
Really could use some help!
Here's the story... I have a renegade 850 mono amp. I recently got my hands on some of the old model 8810 Eclipse subs. The problem is that they are 6 ohm speakers. The amp runs at 2 ohms. If wire the subs together parrallel with them being DVC, they will be 1.5 ohms. Will this be close enough? How will this affect my subs/amp?
Secondary note: Someone tried telling me to swap out the amp fuse with a 40amp fuse.... Am I wrong for thinking he's out of his mind? Not to mention the reason he said to do this was to give the Amp more power.
Secondary note: Someone tried telling me to swap out the amp fuse with a 40amp fuse.... Am I wrong for thinking he's out of his mind? Not to mention the reason he said to do this was to give the Amp more power.
#2
Here's the story... I have a renegade 850 mono amp. I recently got my hands on some of the old model 8810 Eclipse subs. The problem is that they are 6 ohm speakers. The amp runs at 2 ohms. If wire the subs together parrallel with them being DVC, they will be 1.5 ohms. Will this be close enough? How will this affect my subs/amp?
Secondary note: Someone tried telling me to swap out the amp fuse with a 40amp fuse.... Am I wrong for thinking he's out of his mind? Not to mention the reason he said to do this was to give the Amp more power.
Secondary note: Someone tried telling me to swap out the amp fuse with a 40amp fuse.... Am I wrong for thinking he's out of his mind? Not to mention the reason he said to do this was to give the Amp more power.
#3
If they are DVC 6 ohm, you cannot do 3 ohms. Either 6 or 1.5.
If they are the 8810.6 (single 6 ohm voice coil) then you can do 3 ohms.
Personally I'd do 1.5 and make sure you have a good ground and decent 4 guage wiring. Running at 6 ohms you won't get much power at all.
If they are the 8810.6 (single 6 ohm voice coil) then you can do 3 ohms.
Personally I'd do 1.5 and make sure you have a good ground and decent 4 guage wiring. Running at 6 ohms you won't get much power at all.
#4
D'oh brain fart. Yes you are correct 6 or 1.5 only. I would also take my chances with 1.5, but I like to abuse stuff. LOL My 80 watt rms components have been running off 230 watts each for 3 years now and no issues YET. LOL
Thread
Thread Starter
Forum
Replies
Last Post
zigzag420
General Discussion
2
09-01-2011 02:29 PM
MrEastSide
Off-topic Chat
1
03-04-2005 06:43 PM