Shut off System, amp goes into protect
Shut off System, amp goes into protect
hi guys
this is weird when i shut down my system seems like my amps are going into protect mode, drawing current and killing my battery
Zapco dc650.6/dc1100.1
any ideas?
this is weird when i shut down my system seems like my amps are going into protect mode, drawing current and killing my battery
Zapco dc650.6/dc1100.1
any ideas?
Does the red or green light stay on?
Check your ground at the amps
Check and see if you have your Accessory and 12vDC constant wire reversed.
Check with a Multimeter if your deck is sending a remote signal after the car has been shut down.
Did this all of a sudden happen or is this a fresh install?
Vehicle make and model?
Power and Ground gauge? Does the ground go the body or direct to the battery?
Check your ground at the amps
Check and see if you have your Accessory and 12vDC constant wire reversed.
Check with a Multimeter if your deck is sending a remote signal after the car has been shut down.
Did this all of a sudden happen or is this a fresh install?
Vehicle make and model?
Power and Ground gauge? Does the ground go the body or direct to the battery?
Thread
Thread Starter
Forum
Replies
Last Post
belcom
General Discussion
8
Apr 26, 2007 10:55 AM



