*pics* '05 Lancer full trunk and sexy HU install
#13
Clean and simple. Nice work. Is it me though or is the amp a bit crooked? Pics 1, 2 and 5 make it look like the amp isn't quite parallel.
As for the deck, did you use the metal face of it as a template or guide to know where to cut the holes in the CF? Still not entirely clear on how you did that to make it line up. And if you have to service or remove the deck, the whole bezel is now a part of the front face of the deck?
As for the deck, did you use the metal face of it as a template or guide to know where to cut the holes in the CF? Still not entirely clear on how you did that to make it line up. And if you have to service or remove the deck, the whole bezel is now a part of the front face of the deck?
#14
The dash bezel incorporates the face of the deck, it was carefully pried off and cleaned of all the adhesive, then the deck was installed as it sits now, and the face was placed on it, then epoxied to the dash bezel, which had already been prepared by sanding the areas that were to be glued. then the large gaps were filled with epoxy and body filler, sanded and prepped for the carbon fibre. it was a very long process, but i like it.
and the pics are on bad angles, the amp is perfectly aligned.
and the pics are on bad angles, the amp is perfectly aligned.
Thread
Thread Starter
Forum
Replies
Last Post
eggy
General Discussion
20
12-23-2006 03:46 PM