2 way coaxial system
#11
4x60 watts is fine. virtually all stand alone amplifiers have a defeatable or flat setting for the cross over. It'll usually say; LP off HP or LP FLAT HP, this means low pass off high pass. SOme exceptions would be subwoofer amps that are frequency limited to usually under 400 hz, in which case they'll have just a low pass (LP) x over. Variable just means you can set the actual frequency cut off within a range, as opposed to set crossover points ie. 50, 80, 100 hz. That Profile amp has a spot in the middle called "full" that's the same as off of no cross over( I saw the photo of it on the crutchfield website). It's good to go!
what about this one for the sub?
Profile AP700M Mono subwoofer amplifier 350 RMS watts x 1 at 2 ohms at Crutchfield.com
i cannot locate the same "full" setting in the picture provided.
thanks¸
Jazz
Thread
Thread Starter
Forum
Replies
Last Post
BIG UNIT
Car Audio Wanted (WTB)
0
03-23-2007 06:33 PM
Hardcore Rock Superstar
General Discussion
4
04-27-2004 10:09 PM