Anybody know their Zappco's?
#1
ok right now i have a Zappco AG750 running a 18" inhuman @4ohms. i am getting the sub reconed this week and was wondering if this amp can handle a 2ohm load without any problems. if so i am going to have it dual 1ohm voice coils so i can run @ 2ohms i have been told that it can but i would like to see what you guys have to say. thanks! [img]graemlins/thumb.gif[/img]
#2
http://www.carreview.com/Amplifiers/...x.aspx#reviews
Third review down, the dude says he runs his at 2 ohm mono. HTH.
Third review down, the dude says he runs his at 2 ohm mono. HTH.
#8
Guest
Posts: n/a
I also checked this out when I was looking at purchasing my Zaps. If your looking at just the specs from the factory, they do not reccomend running 2 ohm mono.
BUT from the majority of people I had talked with that had experience with the amps, they will run fine with a 2 ohm mono load.
I still have yet to put mine down to 2 ohm mono, but I am sure it will handle it fine. To be honest I have my AG350 running 8 ohm mono [img]tongue.gif[/img]
My IDQ 12 loves it right were it is.
BUT from the majority of people I had talked with that had experience with the amps, they will run fine with a 2 ohm mono load.
I still have yet to put mine down to 2 ohm mono, but I am sure it will handle it fine. To be honest I have my AG350 running 8 ohm mono [img]tongue.gif[/img]
My IDQ 12 loves it right were it is.
#10
Originally posted by lemonlime:
If you are going to be pushing the amp hard (for SPL etc) I would probably recommend against running it in a 2ohm configuration.
If you are going to be pushing the amp hard (for SPL etc) I would probably recommend against running it in a 2ohm configuration.
[ March 09, 2004, 06:32 PM: Message edited by: Team Obsession ]