Can this happen?
I have a set of 6.5 Infinity Kappa Perfect components in my front doors and been having some problems with my amps reading a low impedence load at higher volumes. My SS 700s shifts to high current from high power and when I hook up my older PPI AM 2150 the low impedence light blinks? Yet when I test the speaker leads to the Xovers they both read 4.1 ohms. There dosent seem to be any problems a moderate levels but once you turn it up it happens. Can there be a problem with the speakers/Xovers at higher volumes? Has any one heard of this happening?
Thanks
Thanks
Guest
Posts: n/a
have you checked for a high impedance short to ground
my SS rubi's would cut out and the prot light would come on when I cranked it up, found a 12Kohm reading to ground on one of my tweeter leads .......ran a new wire (was using the factory wires) and no more problems
my SS rubi's would cut out and the prot light would come on when I cranked it up, found a 12Kohm reading to ground on one of my tweeter leads .......ran a new wire (was using the factory wires) and no more problems
Will check it out but I ran new wires and soldered the conections when I installed them so.....? I wonder if I am overpowering them and they are botteming out or something? Thanks for the reply
Thread
Thread Starter
Forum
Replies
Last Post
Buffdaddy
Canadian General Car Audio Discussion
24
Feb 17, 2004 06:48 AM
