I just picked up an amp for my dads car, an urban audio purple joby 300x1@4 ohms max

I got it bridged @2 ohms mono and its not even breakin a sweat?
what gives???
Also have a friend whos beatin the royal **** out of a pyle amp the same way and that amp keeps poundin??
So why not show any 4 ohm mono 2 channel amp a 2 ohm load? [img]graemlins/dunno.gif[/img]
Youre thoughts??

 

the parts they use proboly have a large varience in quality.

one amp may run that out of 10 or so . so they cant claim the rating if all the amps cant do it.

 

Amps are rated for the best possible senario. Everyone knows that if you have a really good power source heavy wire and so on the amp will most likely run like that for ever, but they have to assume everyone is running 22gauge power at 30ft. and no backup and thier alt and batt. are shot and this way they dont get a million returns a year.

If you cant deliver what the amp needs it will fail or over heat or crap out. So build it and rate it to the worst of conditions.

 

It hasent gotten very hot yet,well its getting hot but not burn youre fingers type of hot.
We'll see how long it lasts like that....

 

He He always fun to see the potential. [img]smile.gif[/img]