Car Audio Forumz - The #1 Car Audio Forum

Car Audio Forumz - The #1 Car Audio Forum (https://www.caraudioforumz.com/)
-   General Discussion (https://www.caraudioforumz.com/general-discussion-10/)
-   -   deck shuts off when the stereo is at its loudest!?! (https://www.caraudioforumz.com/general-discussion-10/deck-shuts-off-when-stereo-its-loudest-20799/)

JL_sunfire 09-13-2006 05:13 PM

deck shuts off when the stereo is at its loudest!?!
 
I have an alpine "glide touch" head unit and when I crank the stereo.. The deck shuts off then comes back on right away... What would be the cause of this?

System: JL - 1000/1, 2x 12"w6's, 0/1 gage, stock altornator, 1 farad cap.

could this be because of a voltage drop? (lights dim bad when I drive)

theboy 09-13-2006 05:38 PM

Triple check the ground to the deck!

tristanrules 09-13-2006 05:48 PM

Check the speakers, make sure the OHMS are correct. I had this problem and it was a blown coil of my quad coil sub

theboy 09-13-2006 05:57 PM

that would affect the amp not deck!

JL_sunfire 09-14-2006 06:16 PM

I will check the ground but the power to the deck is not to the battery. It's hooked up to the wire harness.

92zed34 09-14-2006 07:18 PM

Hook it up,just like you would an amp,i used 10 awg from battery to deck,alot of alpine decks require this..
I never really noticed any major improvement,just slightly.

JL_sunfire 09-14-2006 09:17 PM


Originally Posted by 92zed34
Hook it up,just like you would an amp,i used 10 awg from battery to deck,alot of alpine decks require this..
I never really noticed any major improvement,just slightly.

I should put a fuse from the battery to the deck right? If so, what size?

Drew 09-14-2006 10:05 PM


Originally Posted by JL_sunfire
I should put a fuse from the battery to the deck right? If so, what size?

Depends on the size of the wire that you are running...

jim lucas 09-14-2006 10:29 PM

are you runing subs if not there wont be enough voltage drop to shut off the deck. most likely it is a bad ground i would just change that before you do anything if that doesnt fix it then just run a wire to the battery you can do this with power and ground. put a fuse in line with the power and try to keep it as close to the battery as possible use a 10 amp that wouls be fine.

theboy 09-14-2006 10:50 PM

your car has dogsh!t factory wiring, you need to run a new 12awg consatant powr lead to your ignition or battery if you cant figure the ignition out, just do it and be done with it


All times are GMT -5. The time now is 07:58 PM.


© 2024 MH Sub I, LLC dba Internet Brands