LCDS
01-15-2004, 01:23 PM
#1
0 Watt CAFz'r
Thread Starter
Join Date: Oct 2003
Posts: 6
I am considering installing 2 flipdown LCDS in my car. My question is about installing them. What do I attatch them to, obviously I dont drill through the roof. I would like these to be basically inline with teh headrests of the front seats on either side.
any guidance on this would be great [img]smile.gif[/img]
any guidance on this would be great [img]smile.gif[/img]
01-16-2004, 02:20 PM
#5
Guest
Posts: n/a
For the most part the headliner supports everything. You may be lucky or replace a dome light or something and get near a roof support rib to screw to.
Of course if you are really concerned you could silicone a square of plywood to the roof and then screw *carefully* into that.
Of course if you are really concerned you could silicone a square of plywood to the roof and then screw *carefully* into that.
01-17-2004, 12:27 AM
#7
Guest
Posts: n/a
^ Actually they do. If the car is REALLY old, like 60s, it may be merely a fabric sail held in with bow rods. A little newer and they made them from a woodfibre based material that disintegrated over time. Fast forward to now and you have pressed glass fibre that should last forever.
That and most overhead flipdowns are really light. If it is large or a DVD combo then better aim for a roof support or silicone the wood in.
I rechecked your vehicle and in your fullsize blazer I would just make a whole new headliner and mold the screens into it. Not tough in that one. [img]graemlins/thumb.gif[/img]
That and most overhead flipdowns are really light. If it is large or a DVD combo then better aim for a roof support or silicone the wood in.
I rechecked your vehicle and in your fullsize blazer I would just make a whole new headliner and mold the screens into it. Not tough in that one. [img]graemlins/thumb.gif[/img]
