mono and stereo?

Reply Subscribe

Thread Tools

Search this Thread

01-13-2004, 02:07 PM

#11

Paul Niwranski

Guest

Posts: n/a

Quote:

Originally posted by crazyravr:
^^^^ Will that even work ? If you bridge the amp you have output at 4ohm... if you series the coils you have 8ohm and if u parallel them u get 2ohm... Please explain.

Your amp will put out power at any impedance shown to it from very low to very high - it does not 'put out 4 ohms' for instance but rather delivers XXXwatts when a 4 ohm load is connected to it.
Since the amp is rated down to 2 ohms anything below that may damage it but on the top end there really is no limit - the amplifier just keeps making less power as the impedance goes up so most people try to keep it to a nominal 8 ohms.