need help
#3
From a very quick search, I think that the SP10.1 are 4ohm SVC drivers, with a 250WRMS.
If that turns out to be true, I'd check out the Kenwood KAC-8105D mono amp.
The amp will output 500W into a 2 ohm load. If those DB subs are, in fact, 4ohm SVC, then you can wire them for a 2 ohm final load.
I think that'd work out for you.
I purchased that same amp, from OnlineCarStereo.com. It came to $165 CDN, after shipping and duties. Retail, its about $200 before tax.
Check this out >>> https://www.caraudioforumz.com/gener...-build-263139/
If that turns out to be true, I'd check out the Kenwood KAC-8105D mono amp.
The amp will output 500W into a 2 ohm load. If those DB subs are, in fact, 4ohm SVC, then you can wire them for a 2 ohm final load.
I think that'd work out for you.
I purchased that same amp, from OnlineCarStereo.com. It came to $165 CDN, after shipping and duties. Retail, its about $200 before tax.
Check this out >>> https://www.caraudioforumz.com/gener...-build-263139/
Last edited by TragicMagic; 08-29-2012 at 07:30 PM. Reason: I put 4 ohm instead of the required 2 ohm...
Thread
Thread Starter
Forum
Replies
Last Post
Sasq40
General Discussion
11
07-10-2010 12:22 PM
euphoria18_79
General Discussion
6
08-25-2006 07:47 AM
bigdaddydanman
General Discussion
11
09-17-2003 11:56 AM