Need some advice
Since your running W6s you have alot of options. You could either opt for a 4 ohm load or a 1 ohm load.
Since W6s are a classic in my book, you run the amp that was most commonly seen with a trio of W6s... PPI A1200.2
It will do 1200W in a 4 ohm load. The only problem is that they are relatively expensive compared to new amps that are on the market.
For example, a JBL 1200.1 will do 1200W into 1 ohm and will probably cost less than the PPI. Basically any of the Class D out there will work just fine.
Since W6s are a classic in my book, you run the amp that was most commonly seen with a trio of W6s... PPI A1200.2
It will do 1200W in a 4 ohm load. The only problem is that they are relatively expensive compared to new amps that are on the market.
For example, a JBL 1200.1 will do 1200W into 1 ohm and will probably cost less than the PPI. Basically any of the Class D out there will work just fine.
Thread
Thread Starter
Forum
Replies
Last Post
scotiacustom
General Discussion
20
Mar 1, 2007 05:17 PM
Hardcore Rock Superstar
Off-topic Chat
20
Jun 30, 2004 11:29 PM



, The subs are dvc 6ohm, Gmac.