woooo got some PAL card last year when i bought my car so i called the number and apparently im coverd so tow truck just came thought that card was useless to make the customer fell good about buying the car LMAO anywho back to my amp

 

Was the amp new or refurbished "new"?

 

pretty sure it was new, doesnt say new-refurb.
heres the link
NEW MB QUART DSC1000.1 MONO 2000 WATT AMPLIFIER CAR AMP - (eBay.ca item 350158375764 end time 26-Apr-09 04:30:31 EDT)

 

Have you tried popping the speakers with a battery yet?

 

nope how do i do that take the sub out of the box and hook up the 9v to the speaker wire?

 

Yes and just touch the battery to the leads, do not hold it on them. Better yet is to unhook the speaker wire from the amp and test from there.

 

okay but what is that going to solve? my sub is fine, it worked b4 i hooked up to my new amp, while my sub was in my house last week i tested both vc and got 3.9-4.1 ohms on each. its my amp it has to be, it just doesnt make sense that im not get a volt read out on the speaker terminals on the amp

 

To me it looks like your LP is set at 35hz? If it is turned right down you need to turn it 1/3 of the way up. So it points at the W in low. What kind of box this is in will determine where the subsonic gets set. 25hz for sealed and ported is at the tuning of the box.
HTH
Nick

 

haha i havent the slightest clue what is set at with that amp without getting a screwdriver and moving it first, its a X shape slot and both sides are the same width so you dont know where its at POS. but everything was at minimal but im not worried about that i need to set my gain first but i cant as im getin 0 volt read out.

 

Turn the subsonic fully counter-clockwise and the lowpass fully clockwise. Check your fader settings to make sure it's equal F/R. Let us know what happens.