unknown123

Hi everyone!Did you miss me?!? been busy with stuff one question im going to be installing an amp and on my wiring harness there is no option for remote.I have a KDC -MP142CR and it only says theres a:

power control/Motor antenna control wire= blue/white

TEL mute wire=brown

Not Used=Blue
^
|
(This one is weird=p)


which ones my remote????

stephenfleming

iTrader: (1)

Blue/White will be your remote wire.

unknown123

are you sure or is it for the antenna?

BigRedGuy

iTrader: (11)

Yes.....hook it up and then read your manual.......found this link in 30 seconds, on page 16 it tells you what to hook up to that wire......

There seems to be a lot of questions like this......if you don't have the original manual Google is your first "Go-To" source.....

HTH

unknown123

thanks i think i was to lazy to read lol =p

mrezstreet

Blue and white is industry color code for amp turn on if it had blue and blue and white...I'd blue only then blue....some times in a rare case you will fine a off brand of old deck that isn't following code. But its ez to put a test light on it and turn on deck.

Njord

you could also use the ACC line that turns your deck on.

unknown123

thanks guys! i might get my amp in February. I just want to make sure and not make any mistakes =) (safe side )

BigRedGuy

iTrader: (11)

Then when you're ready, PM myself or 420guy.....we'll keep you away from the dark side......

HTH

420guy

iTrader: (5)

Good advice right there. LOL