Pioneer GM-H amp hookup
#2
Took it apart, on the circuit board the terminals are labelled B REM, ACC, and ILM. If I tap a wire off my power supply from the + 12v over to the REM terminal it would turn on? Or would I need to hook up the ACC one also, to an ignition source, when I hook this up in my car? Any old school cats remember? Thanks!!
[ January 08, 2005, 08:33 PM: Message edited by: Jeepbeats ]
[ January 08, 2005, 08:33 PM: Message edited by: Jeepbeats ]
#8
I still have a GM-H50...What a tank... Although it only delivered 2x25W into 4 ohms, they were capable of running 2 ohms mono which gave you around 180W. It was perfect for my JBL DVC 10". I paid next to nothing for it and it was awesome.
I'm always looking for another 2 or 3. From previous posts I believe the H100 uses the same board as the H50 but uses a larger heatsink.
I'm always looking for another 2 or 3. From previous posts I believe the H100 uses the same board as the H50 but uses a larger heatsink.
#10
i have the same amp GM H100 and i was wondering if any one had any decent pics of the amp so i could figure out what the 3 controls are and i am tryin to under stant the 3 wire hookup i am to connect the acc to the b-rem does the acc have power or am i too hook up the remote from the deck thankyou