Question about wiring...
#1
Question about wiring...
Hi all, old reader coming back to ask a question.
I have an old Neon with an AudioBahn 2 channel amp. The front end has 2 way PG 6.5 components. The rear has the stock 6x9's.
Anyhow, if I was to hook up the 6x9's as well as the components up to the amp, will my crossover on the components get messed up?!?!?
I used to have a larger system but I sold out the bass amp/subs so now I just want basic sound. I have some resistors to "take out the treble" on the 6x9's, but I need to know if this can work , or if it will mess up the crossover points on the components.
Or should I just find a cheap 4 channel amp!? Thanks
I have an old Neon with an AudioBahn 2 channel amp. The front end has 2 way PG 6.5 components. The rear has the stock 6x9's.
Anyhow, if I was to hook up the 6x9's as well as the components up to the amp, will my crossover on the components get messed up?!?!?
I used to have a larger system but I sold out the bass amp/subs so now I just want basic sound. I have some resistors to "take out the treble" on the 6x9's, but I need to know if this can work , or if it will mess up the crossover points on the components.
Or should I just find a cheap 4 channel amp!? Thanks
Last edited by gemini8026; 11-20-2006 at 05:24 PM.
#2
should be ok but make sure the stockers are not less then 4 ohms,the stock 6x9s i took outta my lumina were 1 ohm lol.
But as far as crossover points for youre comps,thats done with the module after the amp(so it wont bother them).
But as far as crossover points for youre comps,thats done with the module after the amp(so it wont bother them).
Thread
Thread Starter
Forum
Replies
Last Post
AeR0
Car Audio For Sale
7
11-15-2011 09:58 PM
Kwalsh24
Install related
3
06-17-2004 02:30 PM