thinking of gettin a new amp and sub. heres the specifics. please tell me if this would work right

kenwood 350 watt amp
• 55 watts RMS x 2 at 4 ohms (150 watts x 1 bridged at 4 ohms)
• built-in low-pass filter (80 Hz fixed, 12 dB/octave)
• line level (RCA) and speaker level inputs

kenwood subwoofer 10"
- 10" & 12" subwoofers witha single 4-ohm voice coil
- Stainless steel-coated polypropylene cone
- Rubber surround
- Spring loaded speaker terminals
- Power range: 50-400 watts RMS, 1000 watts peak power
- Frequency response: 25-800 Hz
- Sensitivity: 90 dB
- Mounting depth: 6-11/16"
- Sealed box volume: 1.25 cu. ft.
- Ported box volume: 1.5 cu. ft.
- Warranty: 1 year

please write back asap. thank you very much.

 

it'll work fine, but the sub will be underpowered, and therefore not perform to it's potential. If you could get a 300-400 watt mono amp, that would be better.

 

ik would definitly upgrade the amp..400-500w would do well