Fuzz

Ok. When I installed everything (amp, subs, speakers, etc) into my car, it still had the factory deck installed. There was no RCA PReouts on it... so we used this Pyramid NS-60 Hi/Low Impedance Adapter. It takes 2 speaker inputs, and converts them to RCA.

When I was running with the factory deck, the Amp powered my entire System, so I never used the other speaker wires. Now that the wiring for my amp to power my normal speakers has been removed, I am suck to use the factory deck to power everything again.

Here is my question. Right now, GreenBlack/Purple is just cut, and taped up. My White and Gray run into the Adapter.

When I hook up the harness again, Can I simply run all the speaker wires to the harness, and then do a Wire-tap for the Adapter, or will this create too many problems. I don't want to go without my Subs for a month, but its that, or no radio/cd for a month.

Thanks,

Kev

[ January 14, 2004, 10:12 AM: Message edited by: Fuzz ]

Fuzz

I thought you guys knew everything [img]smile.gif[/img] ... No one knows... The day this happen is the day this site gets shut down.

I [img]graemlins/@bow.gif[/img] to your knowledge

Meh, that, or I'll go for a month without bass, you people would deprive me of that!

camel

the link doesn't work, but i would think that if you hooked up the other speaker wires thwen you would get a mono signal instead of a stero signal. i could be wrong, but i figured i'd give it a shot.