Visonik V109D6 10" 1200watt subwoofers
#2
Hmmm, depends how many you're getting....
1 sub - coils paralleled = 3ohm load...any decent 4ohm capable amp will drive it fine.
2 subs - coils and subs paralleled = 1.5ohm load...most 2ohm mono stable amps will work.
3 subs - coils and subs paralleled = 1ohm load...lots of amps to choose from will do 1 ohm... or you can series the coils and parallel the subs for a 4ohm load.
One of the guys who worked at the XS Cargo store in Miss. put 2 of them on a Clif Designs CDX10A amp....worked very well....good luck with yours.
HTH
1 sub - coils paralleled = 3ohm load...any decent 4ohm capable amp will drive it fine.
2 subs - coils and subs paralleled = 1.5ohm load...most 2ohm mono stable amps will work.
3 subs - coils and subs paralleled = 1ohm load...lots of amps to choose from will do 1 ohm... or you can series the coils and parallel the subs for a 4ohm load.
One of the guys who worked at the XS Cargo store in Miss. put 2 of them on a Clif Designs CDX10A amp....worked very well....good luck with yours.
HTH
#3
Well i piked up two of them and i think i might run them on two seperate amps im thinking two CD500A Clif designs wich will give me a about 800w rms @ 4ohm each speaker so im think these two bad boiz will run great.
#4
I can say from experience with one of those that they are amazing. I was seriously about to give mine away because i hated it so much...until i put it in a different box. I had tried several boxes but nothing sounded good. I ended up putting it in a 1.9 cubic foot box with a 4"x12" round port and it was unbelievable how much it pounded. I ended up getting rid of it when i changed my whole system over after changing vehicles, and still regret it to this day.
i was pretty sure it was rated for 300rms/600peak, but i guess 600rms would make more sense because that thing took a whole lot of power and handled it like a champ.
i was pretty sure it was rated for 300rms/600peak, but i guess 600rms would make more sense because that thing took a whole lot of power and handled it like a champ.
#5
I used those about 3yrs ago, my box was alittle big though. I think it was about 7cf total with 140sq in square slot vent. The box was in my ford tempo firing forward. Damn thing was peaking at 35hz and my best score i could do at that note was 144.1 on the termlab all sealed up on the dash. Oh i forgot to mention that i was using a Mmats D300hc(1200rms@2ohms), worked out great i just ran it at 1.5
Thread
Thread Starter
Forum
Replies
Last Post