winisd hates this sub
#1
when i enter params for this sub winisd gives out to lunch box sizes.mbquart dwf354 15" dvc,4ohm. this is what i could dig up on it
qts-.67
qms-10.34
qes-.720
fs-23hz
re-1.9
le-1.149
vas-151.6
spl-86.4
bl-9.58
sd-.073
pe-350w
ebp-33
going by the low ebp,this sub is going to like a sealed box,correct?manuf. recommends 1.5 cu/ft sealed,win isd says 7.would this driver work in a 4th order bandpass enclosure?if so,can someone help with one seeing as i cand use isd?
thanks
[ July 24, 2005, 10:18 PM: Message edited by: murphman ]
qts-.67
qms-10.34
qes-.720
fs-23hz
re-1.9
le-1.149
vas-151.6
spl-86.4
bl-9.58
sd-.073
pe-350w
ebp-33
going by the low ebp,this sub is going to like a sealed box,correct?manuf. recommends 1.5 cu/ft sealed,win isd says 7.would this driver work in a 4th order bandpass enclosure?if so,can someone help with one seeing as i cand use isd?
thanks
[ July 24, 2005, 10:18 PM: Message edited by: murphman ]
#2
Bassbox gave me 1.1 cubes with no fill in it, for a Qtc of 1.5 (This is a high output box). For high fidelity (SQ) it gave me 10.8 cubes !! That is a .707 alignment, with lots of fill in the box. For vented, it suggested almost 6 cubes.....
#3
thanks jeep. guess i'll tell him to stick with the sealed and we'll put more power to it and see what happens(had it 8ohms on a xtr2150-approx350w i have a bmf 1000 layin around,we'll see what that does for it @2ohms.
thanks again bud
thanks again bud
#6
Thread
Thread Starter
Forum
Replies
Last Post
BoarderDan
General Discussion
1
01-05-2007 03:31 PM