i was checkin out the sundown saz-1000d and on the manual it says it uses 4 gauge(4) for the power supply connectors but when i scroll down through the manual to the section "power connection" it says

Connect the +12V terminal of the amplifier to the + terminal of the battery
using a large gauge power wire (preferably 1/0 gauge).

So which one do I use?

 

4 gauge would be the minimum size to use, but I would go with 1/0 depending on how long the wire will be. Do you have any other amps that you will be running off a Distro block?

 

Just go with 1/0 and only do it once. I went from 8 -> 4 -> 1/0. Save yourself the time and wire it up once.

 

Well I plan on getting an amp later for my speakers/components. So how big is a 1 or 0 gauge wire? How do you exactly hide wire that big lol

 

1/0 ( pronounced one ought) is about half an inch including insulation in diameter.


edit: But it does sepend on manfacturer. Not all car audio wire is created equal


It's also one size larger on the AWG then #1

 

1/0 Gauge is a fair size wire, but depending on your vehicle it can be pretty simple. It is a lot more flexible than you would think.

 

MOST DEFINATELY get some 1/0 and do it once. while your at it do your big 3 in 1/0 if possible and give your electrical system an upgraded favour

 

What wire brands are there? I've only heard of stinger

 

there are lots.. do some research but i run knukonceptz. i love there wire and shipping is always quick and prices are really good. check them out and they should have all the wire and accessories you will need to do an install

 

sorry, kind of off topic but the ssa icon comes in 2 versions, a 1 ohm dual coil and 2 ohm dual coil. what's the difference between them and is it something i shoudl worry about.