Cool very impressive thanks for clearing that up and another quick question what does each amp see if your rise is just over 1ohm.

 

Ok lets start over the amps are strapped from you power test i see over 1ohm after rise so what does each board see for impedance. Do your amps strapp like regular amps do. Because if thats the case each of your amps would see .5-.6 ohms

 

Thank you i understand what you are saying now i was confused because i heard those amps strapp diffrent wich made me think the amps were strapped. So each amp is at 2 ohms after rise. That is a real strong score getting the tunning up should gain you.

 

Murilo whats the lowest impedance 1 amp can see after rise without going into protection.

 

Thats the lowest you can run them but im talking after rise what is the lowest impedance the amp can see. We can run our amps down to .175 starting but the 500.1 must see .9 after rise not to go into protection. The 1100.1 i have heard will work at .675 after rise but i dont suggest people run it that low. The best results we have had was wirring the amp to .25 rising to .8 but that was on 5 cheap 12v and the amp made 11600 rms.