wattage question
#2
safely they can handle the rated amount.....and of clear clean crisp power. if you are feeding them from a distored signal..then id probably half that....if yo are talking about near limits for spl.....safely burp....id say you can go to about 3 times what they are rated for and do a nice burp...
#4
Guest
Posts: n/a
Originally Posted by teamaerostar2
so i could order up 2 of the clarion 1500 watt amps and safely burp these (in a proper box) and not cook them?
need to know before i start ordering equipement.
need to know before i start ordering equipement.
#5
Originally Posted by Wagonized
what load do the clarions put out their 1500 watts compared to the voice coils of your subs?
subs = 500 watts rms / 100 watts peak
Does that help?
#6
Guest
Posts: n/a
Originally Posted by teamaerostar2
amp = 1500 watts rms x 1 @ 1 or 2 ohms
subs = 500 watts rms / 100 watts peak
Does that help?
subs = 500 watts rms / 100 watts peak
Does that help?
Although you're going to have to upgrade some electrical system components in that car to get the most out of the amps.
#8
Originally Posted by Wagonized
yea that would work well. If your subs were dual 2 ohm or dual 4 ohm it will work either way with one amp per.
Although you're going to have to upgrade some electrical system components in that car to get the most out of the amps.
Although you're going to have to upgrade some electrical system components in that car to get the most out of the amps.
Thanks for the info and advice.
#10
Originally Posted by Wagonized
a different box would be a lot cheaper than new amps and could gain you quite a bit aswell if done right.
Will start building as soon as I get the plans.
Thread
Thread Starter
Forum
Replies
Last Post
Father Yuli
General SPL
27
01-12-2005 10:15 PM