Hey guys,

i have a fairly quick easy question. Can i give 2 Brahma MKII 12" subs in a sealed box 2500w RMS? or is that too much not too sure where i can find the subs ratings but would 1250 a piece be safe?


thanks

 

how large of an enclosure? in a Qtc .707 sealed enclosure, the brahma mk1's and mk2's will reach xmax around 900 watts iirc.

 

I was thinking about going 1.25-1.5 per sub. Would i be better off selling my viper amp and getting something with a bit less power.

like 2000w ?

 

or you could turn down the gain to control the output...
have you reviewed the material on the adire audio website about box sizes, response and power handling?

 

Nope. I can never find anything on that site i'll go looking again.

 

http://www.adireaudio.com/Files/BrahmaPowerHandling.pdf\


So according to this file, The brahma will require 900w RMS to reach full extension in a box just under 1Cuft...

Factoring in the 3/4 inch MDF. to get the .92 CUFt i would require a box

13.5 * 13.5 * 12.6 Per sub. Not sure how to factor in the driver displacment into this equation.

Would i be better off with that small box at .92 CUFT with 1000-1200w

or Could i go with a 1.25 CUFT box and give the woofer 1000w RMS
I'm looking for a good combination between a SQ and SPL setup.

 

A lot of headroom is always a good thing.

 

can someone reccomend a box size and design for me? For 2 brahma 12"s sealed preferably