Old School Alpine V12 MRV-F400
#1
Old School Alpine V12 MRV-F400
Ive had this amp for a while now still in mint condition, and its about time to put it to use. Just wandering, would this run my RF P1625's with decent power ? I know its rated 40Rms x 4. What are my options ? Thanks ~ Nelson
Last edited by 01SIlverSc2; 03-23-2006 at 05:04 PM.
#2
I used the MRV-F400 for about seven years in my IASCA system when I was competing in the late '90s.
The amp is rated for 40 watts per channel at 12 volts. At 14.4 you should be getting 60 watts per channel. If that's still not enough, you could bridge the amp to run two channel & have 100 watts per channel at 12 volts & 160 watts per channel at 14.4 volts.
I'm not familiar with the RF speakers but with this amplifier, powering any type of main speaker should be more than adequate.
Good luck!
The amp is rated for 40 watts per channel at 12 volts. At 14.4 you should be getting 60 watts per channel. If that's still not enough, you could bridge the amp to run two channel & have 100 watts per channel at 12 volts & 160 watts per channel at 14.4 volts.
I'm not familiar with the RF speakers but with this amplifier, powering any type of main speaker should be more than adequate.
Good luck!
#5
14.4 volts is the typical vehicle electrical system when the vehicle is running & the audio system is being powered by the battery & alternator. 12 volts is when the vehicle is off & the audio system is only being powered from the battery.
#6
Nice little amp that should do the job for you. It is far from a old school amplifier, old school Alpine is going to say made in Japan on the back and be basic black and maybe just maybe if you are real lucky, a titanium colored one.
Thread
Thread Starter
Forum
Replies
Last Post