amp help
#1
i have a soundstream ref 405s amp
i have included pics of the diagram from the user manual that i am using to hook up:
1 - 12" JL Audio sub
2 - 6" two way 60 watt speakers
a set of 6" mids and two tweets which go through cross over's to reach the amp.
now as you can see in the diagram i have hooked it up the same way. problem is on Channel 1 - 2 i only get the left speaker out put. and on channel 3 - 4 i only receive the right side. when testing i am only using one speaker to test all channels(as i know that the speaker works). i have checked rca's the deck everything and im stumped. can anyone help please.
link to amp pic amp 1
link to amp pic 2 amp 2
[ April 04, 2005, 04:09 PM: Message edited by: GodZilla ]
i have included pics of the diagram from the user manual that i am using to hook up:
1 - 12" JL Audio sub
2 - 6" two way 60 watt speakers
a set of 6" mids and two tweets which go through cross over's to reach the amp.
now as you can see in the diagram i have hooked it up the same way. problem is on Channel 1 - 2 i only get the left speaker out put. and on channel 3 - 4 i only receive the right side. when testing i am only using one speaker to test all channels(as i know that the speaker works). i have checked rca's the deck everything and im stumped. can anyone help please.
link to amp pic amp 1
link to amp pic 2 amp 2
[ April 04, 2005, 04:09 PM: Message edited by: GodZilla ]
#2
are you just running the single input into it. or planing on running seperate front/rear/sub inputs into it. if its just single maybe the way you have the input swithes configured is wrong. maybe just trying running a temp rca from the rear channel and run both inputs into the amp and see if you are still having the same problem.
Thread
Thread Starter
Forum
Replies
Last Post
eldorado76
Car Audio Technical Discussions
13
06-02-2007 12:43 PM