i have an earthquake d1 and it is in protect mode i have the subs wired at 2 ohms power and ground to the battery getting 12.5 volts with engine not running any suggestions on what could be the issue here

 

look at your wireing
or it maybe the amp

 

when looking at the wires what should i be checking for they all seemed to be fine

 

Just take it into Joe and have him look at it for you.

 

thats what i plan on doing a few people told me that the outputs are blown on it but i am going to get justin to take a peak at it
but i sure hope it isntnt something wrong with it since it is the first time i have hooked it up and it would have been a great waste of money if so which meens no car for this year