amp going into protect mode
#1
amp going into protect mode
hey guys, im having problems with my amp going into protect mode when volume is high, the amp is a Sony XM-1252GT and the sub is a AudioBahn AW1208T. now ive had troubles with this sub for a long time, it makes a rattling noise when i put the bass up a bit. when the volume is really low it doesnt rattle but when i put it up just a bit it starts to rattle and crack. i have it wired at 2 ohms and its bridged in the amp. it did the cracking with my other amps as well. what could be wrong with this?
#4
my old amp stopped playing, still powered up and everything but wudnt play. it wasnt in protect mode either it just wouldnt play anything anymore. sometimes when i smacked it hard it started playing for a couple seconds
#5
hey guys, im having problems with my amp going into protect mode when volume is high, the amp is a Sony XM-1252GT and the sub is a AudioBahn AW1208T. now ive had troubles with this sub for a long time, it makes a rattling noise when i put the bass up a bit. when the volume is really low it doesnt rattle but when i put it up just a bit it starts to rattle and crack. i have it wired at 2 ohms and its bridged in the amp. it did the cracking with my other amps as well. what could be wrong with this?
You are overworking the amp by running it 2 ohm mono.
Likewise John Vroom is right. It sounds like you've damaged the voice coil. It that is the case, it likely will give you a different resistance as well.
Perhaps it is time for a different sub to match your amp before this amp just stops working as well.
Thread
Thread Starter
Forum
Replies
Last Post
emarciniak
Car Audio Technical Discussions
34
02-21-2010 02:47 PM
Murkys
Car Audio Technical Discussions
11
05-30-2009 02:07 PM